Page history
11 July 2023
→III. JOINING BOTH PARTS AND CLOSING THE CASE
-5
→II. TOP PART
-4
→I. BOTTOM PART
-3
→I. BOTTOM PART
+5
4 July 2023
→Step 16: Attach and secure the knobs: Grammar
+9
→Step 15: Close the aluminum case: Grammar
+10
→Step 14: Plug the control flat cable into the main board: Grammar
+20
→Step 13: Plug the display flat cable into the display: Grammar
+22
→Step 12: Secure the control board, silicone buttons and display to the aluminum case top: Grammar
+9
→Step 2: Install the display ribbon cable to the RPi4: Grammar
+5
→Step 11: Plug the flat ribbon cable into the control board: Grammar
+14
→Step 10: Assemble the display on the control board: Grammar
-1
→Step 9: Secure the top-spacers on the control board: Grammar
-2
→Step 8: Secure the thermal block to the aluminum case bottom: Grammar
+7
→Step 6: Plug USB-C adapter: Grammar
+17
→Step 5: Plug SD-card adapter: Grammar
+14
→Step 4: Assemble the Main Board into the aluminum case bottom: Grammar
-3
→Step 3: Install the thermal block: Grammar
+3
→Step 2: Install the display ribbon cable to the RPi4: Grammar
+8
Grammar
-4
→Time Required: Tweaked title
+2
→Tools Required: Tweaked title
+2
26 June 2023
→Step 13: Plug the display flat cable into the display
+30
→Step 14: Plug the control flat cable into the main board
+30
→BOM V5 kit
+61
→Step 3: Fixating the thermal block
-2
→Needed Time
+16
→Previous Requirements
+97
25 June 2023
→Step 16: Plug and secure the knobs
+15
→Step 16: Plug and secure the knobs
-2
→Step 16: Plug and secure the knobs
+13
→Step 16: Plug and secure the knobs
+228
→Step 15: Close the aluminum case
+4
→Step 16: Plug and secure the knobs
+47
→Step 16: Plug and secure the knobs
+786
→Step 15: Close the aluminum case
+4
→Step 15: Close the aluminum case
+792
→General Advice
+158
→Step 14: Plug the control flat cable into the main board
+67
→Step 13: Plug the display ribbon cable into the display
-2
→Step 14: Plug the control ribbon cable into the main board
+780
→Step 13: Plug the display ribbon cable into the display
-1,067
→Step 11: Plug the flat ribbon cable into the control board
+136
→Step 6: Plug USB-C adapter
+136
→Step 5: Plug SD-card adapter
+136
→Step 2: Fixate the display ribbon cable to the RPi4
+136
→III. JOINING BOTH PARTS AND CLOSING THE CASE
+1,849
→Step 9: Secure the top-spacers on the control board
+77
→Step 9: Secure the top-spacers on the control board
+194
→Step 12: Secure the control board, silicone buttons and display to the aluminum case top
+1,694