Changes

[[File:capture000090_fixed_wiki.JPG|600px|right]]

[[File:capture000090_fixed_wiki.JPG|600px|right]]

'''2.''' If you don't want your zynthian V5 behaves like a rattle, please, remove the nuts and rings from the rotary encoders. You don't need these, so you can throw them away or put in the screws tray.

'''2.''' If you don't want your zynthian V5 to behave like a rattle, please, remove the nuts and rings from the rotary encoders. You don't need these, so you can throw them away or put in the screws tray.

<br clear=all>

<br clear=all>

[[File:capture000068_fixed_wiki.JPG|600px|right]]

[[File:capture000068_fixed_wiki.JPG|600px|right]]

'''4.''' Secure the 8 x spacers in the control board's top side. For doing this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you could use it if you like.

'''4.''' Secure the 8 x spacers in the control board's top side. To do this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you could use it if you like.

<br clear=all>

<br clear=all>