3,509
edits
Changes
Jump to navigation
Jump to search
→Step 16: Plug and secure the knobs
Line 579:
Line 579:
+
+
+
+
+[[File:capture000125_fixed_wiki.jpg|600px|right]]
−
<br clear=all>
<br clear=all>
−[[File:capture000120_fixed_wiki.jpg|600px|right]]
+[[File:capture000131_fixed_wiki.jpg|600px|right]]
−'''1.''' Take the 4 x mechanized aluminum knobs from the wiring bag and the 4 tiny .
+'''1.''' Take the 4 x mechanized aluminum knobs from the wiring bag and the 4 x super-tiny DIN916 M3 (headless).
−4 x DIN916 M3x4mm black zinc steel (headless)
+<br clear=all>
+[[File:capture000132_fixed_wiki.jpg|600px|right]]
+[[File:capture000133_fixed_wiki.jpg|600px|right]]
+'''2.''' Insert the headless screw in the allen wrench and screw it partially into the knob side hole, until its head is slighty over the knob side.
+<br clear=all>
+[[File:capture000135_fixed_wiki.jpg|600px|right]]
+'''3.''' Repeat the step for the 4 knobs..
<br clear=all>
<br clear=all>
−[[File:capture000121_fixed_wiki.jpg|600px|right]]
+[[File:capture000136_fixed_wiki.jpg|600px|right]]
−'''2.''' Note the way the display flat cable naturally bends. You should force this bending by pressing with your fingers and marking a 45º fold. Zoom in the picture to see the detail.
+'''4.''' Turn the 4 x rotary encoders until the flat cotter is pointing outside.
<br clear=all>
<br clear=all>
−[[File:capture000123_fixed_wiki.jpg|600px|right]]
+[[File:capture000137_fixed_wiki.jpg|600px|right]]
−'''3.''' Close the case slowly, taking care of the cables not being trapped.
+'''5.''' Tight the headless screws. Enough but not too much.
<br clear=all>
<br clear=all>
−[[File:capture000124_fixed_wiki.jpg|600px|right]]
+[[File:capture000140_fixed_wiki.jpg|600px|right]]
−'''4.''' Take the remaining 6 x ISO M3 screws and secure the case, 3 on each side. Tight enough, but not too much.
+'''6.''' Congratulations! Your Zynthian V5 is ready to boot for first time. It's time to [[Zynthian Software|burn the SD-card with the latest SD-image]].
<br clear=all>
<br clear=all>