3,418
edits
Changes
Jump to navigation
Jump to search
Line 520:
Line 520: − − [[File:capture000094_fixed_wiki.jpg|600px|right]] − − '''4.''' Use the "Screens & Bits" case as a mounting stand and place the control board on it, like shown in the picture. − − <br clear=all> − − [[File:capture000095_fixed_wiki.jpg|600px|right]] − − '''5.''' Place the aluminum case top part over the control board taking care of orientation and proceeding slowly. It's a good time to remove the display's protective sheet, or at less, − fold the green tab out of the way so the display make a good fit into the case's window. − − <br clear=all> − − [[File:capture000101_fixed_wiki.jpg|600px|right]] − − '''6.''' Secure the control board with the 8 x M3 conic screws. Again, tight enough, but not too much. − − <br clear=all> − − [[File:capture000102_fixed_wiki.jpg|600px|right]] − − '''7.''' Flip the top part and place it over the cartoon-stand again. Now is the right moment to tight the 4 display screws from step 11 (do you remember?). − − <br clear=all> − − [[File:capture000103_fixed_wiki.jpg|600px|right]] − − '''8.''' Congratulations! We are ready to join everything together. − − <br clear=all> −
→Step 13: Plug the display ribbon cable into the display
<br clear=all>
<br clear=all>
=='''Step 14: Plug the control ribbon cable into the main board'''==
=='''Step 14: Plug the control ribbon cable into the main board'''==