3,418
edits
Changes
Jump to navigation
Jump to search
Line 502:
Line 502: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→III. JOINING BOTH PARTS AND CLOSING THE CASE
<br clear=all>
<br clear=all>
[[File:capture000106_fixed_wiki.jpg|600px|right]]
'''1.''' Place the two parts one aside the other, forming 90º angle, as shown in the picture.
<br clear=all>
[[File:capture000109_fixed_wiki.jpg|600px|right]]
'''2.''' Using two fingers, one each hand, softly pull the display's FPC tongue until it's open. Insert the flat ribbon cable coming from the RPi4 in the bottom's part. Do it straight, without bending or twisting it in any way.
<br clear=all>
[[File:capture000110_fixed_wiki.jpg|600px|right]]
'''3.''' When it's totally inserted, softly push the tongue using 2 fingers, one each hand, until it's totally closed. Put attention to the cable not moving out the connector. If it's not well inserted or not straight, repeat the operation until it's OK.
<br clear=all>
[[File:capture000094_fixed_wiki.jpg|600px|right]]
'''4.''' Use the "Screens & Bits" case as a mounting stand and place the control board on it, like shown in the picture.
<br clear=all>
[[File:capture000095_fixed_wiki.jpg|600px|right]]
'''5.''' Place the aluminum case top part over the control board taking care of orientation and proceeding slowly. It's a good time to remove the display's protective sheet, or at less,
fold the green tab out of the way so the display make a good fit into the case's window.
<br clear=all>
[[File:capture000101_fixed_wiki.jpg|600px|right]]
'''6.''' Secure the control board with the 8 x M3 conic screws. Again, tight enough, but not too much.
<br clear=all>
[[File:capture000102_fixed_wiki.jpg|600px|right]]
'''7.''' Flip the top part and place it over the cartoon-stand again. Now is the right moment to tight the 4 display screws from step 11 (do you remember?).
<br clear=all>
[[File:capture000103_fixed_wiki.jpg|600px|right]]
'''8.''' Congratulations! We are ready to join everything together.
<br clear=all>
=='''Step 14: Plug the control ribbon cable into the main board'''==
=='''Step 14: Plug the control ribbon cable into the main board'''==