Changes

[[File:capture000099_fixed_wiki.jpg|600px|right]]

[[File:capture000099_fixed_wiki.jpg|600px|right]]

'''2.''' Look for 8 x DIN7991 M3 screws. They have conic-flat head.

'''2.''' Look for 8 x DIN7991 M3 screws. They have countersunk flat heads.

<br clear=all>

<br clear=all>

[[File:capture000089_fixed_wiki.jpg|600px|right]]

[[File:capture000089_fixed_wiki.jpg|600px|right]]

'''3.''' Place the silicone buttons on its place, on top the control board. Note the tiny silicone nipples in the bottom and put attention to get them fit into the small placing-holes on the control board. Once it's done, softly side-push to check the buttons are well sited in its place. They shouldn't move.

'''3.''' Place the silicone buttons in place, on top the control board. Note the tiny silicone nipples in the bottom and pay attention to get them to fit into the small locating-holes on the control board. Once it's done, softly side-push to check the buttons are well sited in place. They shouldn't move.

<br clear=all>

<br clear=all>

[[File:capture000094_fixed_wiki.jpg|600px|right]]

[[File:capture000094_fixed_wiki.jpg|600px|right]]

'''4.''' Use the "Screens & Bits" case as a mounting stand and place the control board on it, like shown in the picture.  

'''4.''' Use the "Screens & Bits" case as a mounting stand and place the control board on it, as shown in the picture.  

<br clear=all>

<br clear=all>

[[File:capture000095_fixed_wiki.jpg|600px|right]]

[[File:capture000095_fixed_wiki.jpg|600px|right]]

'''5.''' Place the aluminum case top part over the control board taking care of orientation and proceeding slowly. It's a good time to remove the display's protective sheet, or at less,  

'''5.''' Place the aluminum case top part over the control board taking care of orientation and proceeding slowly. It's a good time to remove the display's protective sheet, or at least, fold the green tab out of the way so the display makes a good fit into the case's window.

fold the green tab out of the way so the display make a good fit into the case's window.

<br clear=all>

<br clear=all>

[[File:capture000101_fixed_wiki.jpg|600px|right]]

[[File:capture000101_fixed_wiki.jpg|600px|right]]

'''6.''' Secure the control board with the 8 x M3 conic screws. Again, tight enough, but not too much.

'''6.''' Secure the control board with the 8 x M3 countersunk screws. Again, tighten enough, but not too much.

<br clear=all>

<br clear=all>

[[File:capture000102_fixed_wiki.jpg|600px|right]]

[[File:capture000102_fixed_wiki.jpg|600px|right]]

'''7.''' Flip the top part and place it over the cartoon-stand again. Now is the right moment to tight the 4 display screws from step 11 (do you remember?).

'''7.''' Flip the top part and place it over the carton-stand again. Now is the right moment to tight the 4 display screws from step 11 (do you remember?).

<br clear=all>

<br clear=all>