505
edits
Changes
Jump to navigation
Jump to search
Line 407:
Line 407: − + Line 413:
Line 413: − + Line 420:
Line 420: − +
→Step 10: Assemble the display on the control board: Grammar
[[File:capture000072_fixed_wiki.JPG|600px|right]]
[[File:capture000072_fixed_wiki.JPG|600px|right]]
'''1.''' Take the display from its case and remove the 4 yellow protective sheets from the more external spacers. You could use your finger-nail or a cutter for this operation.
'''1.''' Take the display from its case and remove the 4 yellow protective sheets from the outer spacers. You could use your fingernail or a cutter for this operation.
<br clear=all>
<br clear=all>
[[File:IMG_4191_fixed_wiki.JPG|600px|right]]
[[File:IMG_4191_fixed_wiki.JPG|600px|right]]
'''2.''' Take 4 x ISO7380 M2.5 screws (the smaller ones with round head).
'''2.''' Take 4 x ISO7380 M2.5 screws (the smaller ones with round heads).
<br clear=all>
<br clear=all>
[[File:capture000073_fixed_wiki.JPG|600px|right]]
[[File:capture000073_fixed_wiki.JPG|600px|right]]
'''3.''' Secure the display to the control board's top side using the 4 x small M2.5 screws. '''Don't tight these bolts yet!!!''' The display must be loose to get a good fit with the aluminum case top part. You will tight these screws later. Put attention to the display orientation. The display FPC connector for the flat cable must be accessible thru the main board's square hole.
'''3.''' Secure the display to the control board's top side using the 4 x small M2.5 screws. '''Don't tighten these bolts yet!!!''' The display must be loose to get a good fit with the aluminum case top part. You will tighten these screws later. Pay attention to the display orientation. The display FPC connector for the flat cable must be accessible through the main board's square hole.
<br clear=all>
<br clear=all>