Changes

When it's done, you have to plug the LED wires into the 2 spare "DUPONT" connectors from the MIDI harness (green & yellow wires). Polarity is important, so don't cross the wires:

When it's done, you have to plug the LED wires into the 2 spare "DUPONT" connectors from the MIDI harness (green & yellow wires). Polarity is important, so don't cross the wires:

  * JST Green wire (1) => LED's Anode (LED's long lead)

  * JST Green wire (1) => LED's long lead (Anode)

  * JST Yellow wire (2) => LED's Cathode (LED's short lead)

  * JST Yellow wire (2) => LED's short lead (LED's Cathode)

Since the LED's leads are too long, you will want to cut them down to about 7-8mm. Make sure you remember which lead is the short one. When inserting the DuPont connector, if you feel that it doesn't grab the pins enough, you should press the tiny metal-jacket inside the plastic capsule to make it narrow. It's easy, simply put the DuPont connector over the desk and press the metal with the screwdriver tip or something like that.

Since the LED's leads are too long, you will want to cut them down to about 7-8mm. Make sure you remember which lead is the short one. (You could mark the inside of the case with pencil as a reminder.) When inserting the DuPont connector, if you feel that it doesn't grab the pins enough, you should press the tiny metal-jacket inside the plastic capsule to make it narrow. It's easy, simply put the DuPont connector over the desk and press the metal with the screwdriver tip or something like that.

[[File:IMG2406_fixv41.JPG|800px]]

[[File:IMG2406_fixv41.JPG|800px]]

{{NoteBox|If you don’t connect the status LEDs, the MIDI-OUT and MIDI-THRU won’t work unless you short the JP1 & JP2 jumpers on the zynaptik board.}}

{{NoteBox|If wish to omit the status LEDs you must short JP1 & JP2 jumpers on the Zynaptik board otherwise the MIDI-OUT and MIDI-THRU won’t work.}}

===Prepare the Zynductor Passive Cooler===

===Prepare the Zynductor Passive Cooler===