Line 147: |
Line 147: |
| | | |
| [[File:IMG2406.JPG|600px]] | | [[File:IMG2406.JPG|600px]] |
| + | |
| + | {{NoteBox|If you don’t connect the status LEDs, the MIDI-OUT and MIDI-THRU won’t work unless you short jumpers JP1 & JP2 in the zynaptik board.}} |
| | | |
| ===Assemble the Main Computing Block=== | | ===Assemble the Main Computing Block=== |
Line 193: |
Line 195: |
| [[File:IMG_1295.JPG|400px]] | | [[File:IMG_1295.JPG|400px]] |
| | | |
− | It's composed of 4 bolts, 4 nuts and 4 nylon separators. Before fixing the screen, don't forget to remove the protective plastic sheet. | + | It's composed of 4 bolts, 4 nuts and 4 nylon separators. Before securing the screen, don't forget to remove the protective plastic sheet. For tightening the bolts you could use a 2mm Allen key while hold the nut with your fingers. |
| | | |
| [[File:IMG_2423.JPG|600px]] | | [[File:IMG_2423.JPG|600px]] |
Line 203: |
Line 205: |
| [[File:Rotary&wire.JPG|600px]] | | [[File:Rotary&wire.JPG|600px]] |
| | | |
− | Fix the 4 controller modules to the case cover using the 4 bolts and washers attached to every rotary encoder. | + | Fix the 4 controller modules to the case cover using the 4 nuts and washers attached to every rotary encoder. |
| | | |
| [[File:ZynScreen&Controller.JPG|600px]] | | [[File:ZynScreen&Controller.JPG|600px]] |
Line 238: |
Line 240: |
| | | |
| [[File:MIDIConnector.JPG|600px]] | | [[File:MIDIConnector.JPG|600px]] |
| + | |
| + | {{NoteBox|If you don’t connect the status LEDs, the MIDI-OUT and MIDI-THRU won’t work unless you short jumpers JP1 & JP2 in the zynaptik board.}} |
| | | |
| | | |