2,705
edits
Changes
Jump to navigation
Jump to search
Line 274:
Line 274: − + − +
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 16:19, 15 July 2019
, 16:19, 15 July 2019→First Boot
When you are sure that everything is in its place, it's time to boot by first time, so:
When you are sure that everything is in its place, it's time to boot by first time, so:
1. Insert the SD-card with the zynthian image ready to run. If you don't have one yet, [[#Zynthian_Software|read this]].
1. Insert the SD-card with the zynthian image ready to run. If you don't have one yet, [[#Zynthian_Software|read this]]. You can insert the SD-card through the "window" on the bottom-side of the case. Also, if the case is still open, you can do it from the top.
2. Plug the mini-usb power conector. A good 5V micro-usb charger is recommended (> 2 Amp).
2. Plug the mini-usb power connector. A good 5V micro-usb charger is recommended (> 2 Amp).
These are the stages that you should see while booting:
These are the stages that you should see while booting: