240
edits
Changes
Jump to navigation
Jump to search
Line 242:
Line 242: + + + + Line 258:
Line 262: − + Line 272:
Line 276: − + Line 358:
Line 362: − +
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 16:36, 11 July 2019
, 16:36, 11 July 2019→First Boot
[[File:Screen&Ribbon.JPG|600px]]
[[File:Screen&Ribbon.JPG|600px]]
At this point, your Zynthian Box should look something like this:
[[File:Precierre.JPG|600px]]
=Testing your Zynthian Box=
=Testing your Zynthian Box=
2. Plug the mini-usb power conector. A good 5V micro-usb charger is recommended (> 2 Amp).
2. Plug the mini-usb power conector. A good 5V micro-usb charger is recommended (> 2 Amp).
If you are using a SD image pre-configured for the Zynthian Kits v2, these are the stages that you should see while booting:
If you are using a SD image pre-configured for the Zynthian Kits v3, these are the stages that you should see while booting:
1. Initially, the display must go white
1. Initially, the display must go white
If not, bad luck! Probably you made some mistake during the mounting process. You have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
If not, bad luck! Probably you made some mistake during the mounting process. You have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
If you are using an older SD image that is not pre-configure for the Kit v2, then you should configure your Zynthian Box's hardware using the [[Configuration_Users_Guide|webconf tool]]. These are the adjustments you have to do:
If you are using an older SD image that is not pre-configure for the Kit v3, then you should configure your Zynthian Box's hardware using the [[Configuration_Users_Guide|webconf tool]]. These are the adjustments you have to do:
* '''Display:''' PiScreen 3.5 (v2)
* '''Display:''' PiScreen 3.5 (v2)
Take your time to see how to bend and drive the cables to get a good fitting when closing the case.
Take your time to see how to bend and drive the cables to get a good fitting when closing the case.
[[File:IMG_1626.JPG|600px]]
[[File:Precierre.JPG|600px]]
Finally, screw-drive the 8 sheet-threader bolts for securing the case, 4 each side.
Finally, screw-drive the 8 sheet-threader bolts for securing the case, 4 each side.