240
edits
Changes
Jump to navigation
Jump to search
Line 172:
Line 172: − + − + − + − + − After soldering all the 3 LEDs, you may want to protect the connection with heat shrink sleeve, adhesive tape or hot melt glue.+ − −
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 14:33, 11 July 2019
, 14:33, 11 July 2019→Mount the MIDI activity LEDS
Insert the 3 LEDS in the case holes. You may want to push the LEDs with something more rigid than your finger. The screwdriver's handle could be fine.
Insert the 3 LEDS in the case holes. You may want to push the LEDs with something more rigid than your finger. The screwdriver's handle could be fine.
[[File:IMG_2223.JPG|600px]]
[[File:photo-not-available.jpg|600px]]
[[File:IMG_2224.JPG|600px]]
[[File:IMG_2365.JPG|600px]]
When it's done, you have to solder the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (white/yellow). Polarity is important, so don't cross the wires:
When it's done, you have to plug the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (green/yellow). Polarity is important, so don't cross the wires:
* JST White wire (1) => LED's Anode (LED's red wire/long lead)
* JST Green wire (1) => LED's Anode (LED's red wire/long lead)
* JST Yellow wire (2) => LED's Cathode (LED's black wire/short lead)
* JST Yellow wire (2) => LED's Cathode (LED's black wire/short lead)
[[File:photo-not-available.jpg|600px]]
[[File:IMG_2226.JPG|600px]]
===Secure the Display===
===Secure the Display===