2,705
edits
Changes
Jump to navigation
Jump to search
Line 184:
Line 184: − + Line 318:
Line 318: − + Line 348:
Line 348: − + Line 360:
Line 360: − +
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 13:17, 13 January 2020
, 13:17, 13 January 2020→Test the Controllers & UI
[[File:IMG_2410.JPG|600px]]
[[File:IMG_2410.JPG|600px]]
The zynaptik board has some extra circuitry which doesn't have anything soldered on it. These are used for modifying the board, and it is fully functional as it is.
The zynaptik board has some extra circuitry which doesn't have anything soldered on it. These are used for adding extra functionality to the board.
===Mount the Display===
===Mount the Display===
4. After 5-10 seconds, the zynthian UI will be shown
4. After 5-10 seconds, the zynthian UI will be shown
If you get the Zynthian UI, then you have assembled the Zynthian box correctly.
If you get the Zynthian UI, then you have assembled the Zynthian box correctly. Congratulations!
[[file:IMG_2490.JPG|600px]]
[[file:IMG_2490.JPG|600px]]
The selector must go down when rotating clockwise and go up when rotating counter-clockwise. If the rotation sense is reversed, you should check the wiring. Perhaps one of the connections are faulty. The wires' color sequence should be red, black, yellow, green.
The selector must go down when rotating clockwise and go up when rotating counter-clockwise. If the rotation sense is reversed, you should check the wiring. Perhaps one of the connections are faulty. The wires' color sequence should be red, black, yellow, green.
4. Select the ZynAddSubFX engine, select channel #1, select 'Collection' and preset 'Metal Drips' present.
4. Select the ZynAddSubFX engine, select channel #1, select bank 'Collection' and preset 'Metal Drips'.
[[File:IMG_2497.JPG|600px]]
[[File:IMG_2497.JPG|600px]]
If one of the controllers doesn't work correctly, check the wiring again.
If one of the controllers doesn't work correctly, check the wiring again.
6. Push SELECT to move to the next controller screen. Bold push (a push lasting a few seconds) to select a controller screen from the list.
6. Push SELECT to move to the next controller screen. Bold push (a push lasting about 1 second) to select a controller screen from the list.
7. Push BACK. You should go back to the 'Preset Selection' screen.
7. Push BACK. You should go back to the 'Preset Selection' screen.