Changes

===Mount the MIDI activity LEDS===

===Mount the MIDI activity LEDS===

Insert the 3 LEDS in the case holes, leaving the short lead at left. Don't push the LED's head! Instead push the black plastic holder around the LED. Sometimes is hard to push ...

 

 

Insert the 3 LEDS in the case from the inside, leaving the short lead at left. Make sure you push the LEDs by the plastic around the LED, not the LED itself.

[[File:IMG2403.JPG|600px]]

[[File:IMG2403.JPG|600px]]

  * JST Yellow wire (2) => LED's Cathode (LED's short lead)

  * JST Yellow wire (2) => LED's Cathode (LED's short lead)

As the LED's leads are too long, you would like to cut them a little bit (7-8 mm is a good length), but remember where the "short" lead is located!!

Since the LED's leads are too long, you will want to cut them down to about 7-8mm. Make sure you remember which lead is the short one.

[[File:IMG2406.JPG|600px]]

[[File:IMG2406.JPG|600px]]

{{NoteBox|If you don’t connect the status LEDs, the MIDI-OUT and MIDI-THRU won’t work unless you short jumpers JP1 & JP2 in the zynaptik board.}}

{{NoteBox|If you don’t connect the status LEDs, the MIDI-OUT and MIDI-THRU won’t work unless you short the JP1 & JP2 jumpers on the zynaptik board.}}

===Assemble the Main Computing Block===

===Assemble the Main Computing Block===