Line 227: |
Line 227: |
| * Connect the 4 double JST cables to the 4 controller connectors on the ZynScreen (CTRL1, CTRL2, CTRL3, CTRL4) | | * Connect the 4 double JST cables to the 4 controller connectors on the ZynScreen (CTRL1, CTRL2, CTRL3, CTRL4) |
| | | |
− | [[File:Zynscreen&Controllers.JPG|600px]] | + | [[File:ZynScreenConnect.JPG|600px]] |
| | | |
− | * Connect the 2 JST cables from the MIDI connectors to the MIDI-IN and the MIDI-OUT/THRU connectors on the All-In-One module. Note that currently only 2 connectors are available in the official aluminum case, so you have to choose what do you prefer: MIDI-OUT or MIDI-THRU ;-) | + | * Connect the 3 JST cables from the MIDI connectors to the MIDI-IN, MIDI-OUT and MIDI-THRU connectors on the Zynaptik module. |
| | | |
− | [[File:IMG_1465.JPG|600px]] | + | [[File:MIDIConnector.JPG|600px]] |
− | | |
− | At this point, your Zynthian Box should look something like this:
| |
− | | |
− | [[File:IMG_1409.JPG|600px]]
| |
− | | |
− | * Connect the 4 x Controller Modules following the right numbering: from top to bottom and from left to right.
| |
− | | |
− | [[File:zynthian_controllers.png|600px]]
| |
− | | |
− | [[File:IMG_1412.JPG|600px]]
| |
| | | |
| * Connect the Jack connector to the auxiliar audio-out connector on the HifiBerry soundcard. It's the 3-pin JST connector that you soldered before: | | * Connect the Jack connector to the auxiliar audio-out connector on the HifiBerry soundcard. It's the 3-pin JST connector that you soldered before: |
| | | |
− | [[File:IMG_1489.JPG|600px]] | + | [[File:photo-not-available.jpg|600px]] |
| | | |
| ===Connect the Display=== | | ===Connect the Display=== |
| | | |
− | And finally, connect the ribbon's 26-pin connector to the Display's male side connector. Put attention to the orientation. The red wire should be the pin 1 that as marked in the display's PCB surface. | + | And finally, connect the ribbon's 26-pin connector to the Display's male side connector. '''Put attention to the orientation'''. The red wire should be the pin 1 that as marked in the display's PCB surface. |
| | | |
− | [[File:IMG_1501.JPG|600px]] | + | [[File:Screen&Ribbon.JPG|600px]] |
| | | |
| =Testing your Zynthian Box= | | =Testing your Zynthian Box= |