88
edits
Changes
Jump to navigation
Jump to search
Line 425:
Line 425: − + − + Line 435:
Line 435: − +
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 11:38, 13 January 2020
, 11:38, 13 January 2020→Final steps
=Final steps=
=Final steps=
Once everything is in its place and you have tested that it works, it's time to close the case ...
Once everything is in its place and you have tested that it works, it's time to close the case
===Close the case===
===Close the case===
Take your time to see how to bend and drive the cables to get a good fitting when closing the case. The ribbon bus cable is pre-bended for easing this process.
Take your time to bend and push the cables to get a good fit when closing the case. The ribbon bus cable is pre-bent to make this process easier.
Finally, screw-drive the 8 sheet-threader bolts for securing the case, 4 each side.
Finally, fasten the 8 sheet-threaded bolts to secure the case, 4 on each side.