88
edits
Changes
Jump to navigation
Jump to search
Line 210:
Line 210: − +
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 11:14, 13 January 2020
, 11:14, 13 January 2020→Stick the rubber feet
You should attach the knobs into the encoders before closing the case. Push the knobs unto the encoders while pushing the encoder with a finger on the PCB board. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this.
You should attach the knobs into the encoders before closing the case. Push the knobs unto the encoders while pushing the encoder with a finger on the PCB board. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this.
===Stick the rubber feet===
===Attach the rubber feet===
[[File:IMG 2536.JPG|600px]]
[[File:IMG 2536.JPG|600px]]