Changes

[[File:IMG_1401.JPG|600px]]

[[File:IMG_1401.JPG|600px]]

===Insert the knobs===

===Attach the knobs===

You should insert the knobs into the encoders before closing the case. This will avoid forcing the encoders too much as otherwise, you could break them. Follow these simple steps and you wouldn't have any problem:

You should attach the knobs into the encoders before closing the case. Push the knobs unto the encoders while pushing the encoder with a finger on the PCB board. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this.

 

* moisten with water or saliva the encoder stem and the knob hole

* press the encoder PCB with the finger from the rear side while pushing the knob from the front side until is completely inserted

===Stick the rubber feet===

===Stick the rubber feet===