2,718
edits
Changes
Jump to navigation
Jump to search
Line 175:
Line 175: − + + + Line 190:
Line 192: − + − [[File:Controller_single_ensambled_01.jpg|400px]]
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 18:31, 18 October 2017
, 18:31, 18 October 2017→Assembling the Controller Modules
+ 4 x 4-pin JST male-angle connector
+ 4 x 4-pin JST male-angle connector
[[File:4xcontroller_single_kit.jpg|600px]]
[[File:IMG_4728.JPG|600px]]
This components are used to build the 4 controller modules that form the input side of the physical ''Zynthian User Interface''. Each controller embed an incremental rotary encoder and a switch, so 4 wires (A,B,SW,GND) are needed for connecting it.
This components are used to build the 4 controller modules that form the input side of the physical ''Zynthian User Interface''. Each controller embed an incremental rotary encoder and a switch, so 4 wires (A,B,SW,GND) are needed for connecting it.
[[File:IMG_4731.JPG|600px]]
These are the steps for building one module:
These are the steps for building one module:
7. Use the plier to close the tabs again, trying to "catch" the PCB.
7. Use the plier to close the tabs again, trying to "catch" the PCB.
[[File:Controller_single_ensambled_top.jpg|290px]]
[[File:IMG_4781.JPG|600px]]
You have to build 4 controller modules, so you to have to repeat the steps 4 times.
You have to build 4 controller modules, so you to have to repeat the steps 4 times.