2,706
edits
Changes
Jump to navigation
Jump to search
Line 500:
Line 500: − + − + − First, you should insert the knobs into the encoders. You should avoid to force the encoders because it could break:+ + + + − + + +
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 17:22, 24 October 2017
, 17:22, 24 October 2017→Close the Case
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
=Close the Case=
=Final steps=
When everything is working OK, it's time to close the case.
When everything is working OK, it's time to close the case, but first ...
===Insert the knobs===
You should insert the knobs into the encoders before closing the case. This will avoid forcing the encoders too much as otherwise, you could break them.
Follow these simple steps and you wouldn't have any problem:
* moisten with water or saliva the encoder stem
* moisten with water or saliva the encoder stem
* press the encoder with the finger from the rear while pushing the knob
* press the encoder with the finger from the rear while pushing the knob from the front until is completely inserted
===Close the case===
Once the knobs are in its place, take your time to see how to bend and drive the cables to get a good fitting when closing the case.
Once the knobs are in its place, take your time to see how to bend and drive the cables to get a good fitting when closing the case.