2,706
edits
Changes
Jump to navigation
Jump to search
Line 427:
Line 427: − + − + − +
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 17:27, 23 October 2017
, 17:27, 23 October 2017→Test the Controllers
===Test the Controllers===
===Test the Controllers===
If you get the Zynthian UI, then you should start by testing that your controllers are working OK.
If you get into the Zynthian UI, then you should start by testing that your controllers are working OK.
1. Push the 'SELECT' controller. You should get into the 'Engine Selection' screen.
1. Push 'select'. You should get into the 'Layer Selection' screen.
If it doesn't works, try pushing the 'LS' controller. Perhaps you have cross-wired the 3 & 4 controllers and in that case, you have to fix the wiring. If it doesn't work, try pushing the other two controllers and rotating the controllers. If something happens, most probably you have reversed the wiring order when connecting the controllers, or perhaps you have changed some wires while connecting the main ribbon bus. Double-check the wiring again.
If it doesn't works, try pushing the 'snapshot' controller. Perhaps you have cross-wired the 3 & 4 controllers and in that case, you have to fix the wiring. If it doesn't work, try pushing the other two controllers and rotating the controllers. If something happens, most probably you have reversed the wiring order when connecting the controllers, or perhaps you have changed some wires while connecting the main ribbon bus. Double-check the wiring again.
2. Rotate the 'SELECT' controller to select the engine you want to start.
2. Rotate the 'SELECT' controller to select the engine you want to start.