2,718
edits
Changes
Jump to navigation
Jump to search
Line 217:
Line 217: − + − + + + + + + +
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 10:15, 18 October 2017
, 10:15, 18 October 2017→Assembling the All-In-One Module
[[File:2in1_kit.jpg|600px]]
[[File:2in1_kit.jpg|600px]]
These are the steps for building the 2in1 module:
These are the steps for building the All-In-One module:
0. Be sure that you have read and understood [[#Some_general_recommendations|these recommendations]].
0. Be sure that you have read and understood [[#Some_general_recommendations|these recommendations]].
1. Place all the components in the upside of the PCB (the labeled side!). Put attention to the orientation of the ICs and diodes.
1. Place the passive components (resistors & capacitors) in the upside of the PCB (the labeled side!).
2. Solder the components carefully. Always avoid overheating!
2. Solder the components carefully. Always avoid overheating!
3. Place the ICs and diodes in the upside of the PCB (the labeled side!). Put attention to the orientation of these components!!
4. Solder the components carefully. Always avoid overheating! (*)
5. Place the connectors in the upside of the PCB (the labeled side!).
6. Solder the components carefully. Always avoid overheating! (*)
(*) You could use some tape for fixing the components while soldering, specially for ICs and connectors.
[[File:2in1_ensambled.jpg|600px]]
[[File:2in1_ensambled.jpg|600px]]