2,706
edits
Changes
Jump to navigation
Jump to search
Line 268:
Line 268: − + − + + + + + + +
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 22:01, 10 June 2018
, 22:01, 10 June 2018→Building the MIDI-IN/OUT/THRU connectors
===Building the MIDI-IN/OUT/THRU connectors===
===Building the MIDI-IN/OUT/THRU connectors===
Before mounting the MIDI-IN/OUT/THRU connectors into the case we will solder the needed wires. Doing it in that way is rather more comfortable than trying to solder inside the case with all the wiring mess.
Before mounting the MIDI-IN/OUT/THRU connectors into the case we will solder the needed wires that allow connecting it to the All-In-One circuit using a JST connector. Doing it in that way is rather more comfortable than trying to solder inside the case with all the wiring mess.
[[File:IMG_4777.JPG|600px]]
[[File:IMG_4777.JPG|600px]]
If you want, you can protect the contacts using heat-shrink sleeve (the red sleeve pieces in the photo). In that case, remember to insert the sleeve pieces before soldering ;-)
'''JST Connector wires'''[[File:Midiconnfront.jpg|right]]
* JST Red (1) => pin 4 of MIDI connector
* JST Black (2) => pin 5 of MIDI connector
* JST Yellow (3) => LED's Cathode (LED's black wire/short lead)
* JST White (4) => LED's Anode (LED's red wire/long lead)
If you want (i strongly recommend you do it!), you can protect the contacts using heat-shrink sleeve (the red sleeve pieces in the photo). In that case, remember to insert the sleeve pieces before soldering ;-)
[[File:IMG_1276.JPG|600px]]
[[File:IMG_1276.JPG|600px]]