Changes

Insert the 3 LEDS in the case holes. You may want to push the LEDs with something more rigid than your finger. The screwdriver's handle could be fine.

Insert the 3 LEDS in the case holes. You may want to push the LEDs with something more rigid than your finger. The screwdriver's handle could be fine.

When it's done, you have to solder the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (white/yellow). Polarity is important, so don't cross the wires:

When it's done, you have to solder the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (white/yellow). Polarity is important, so don't cross the wires:

After soldering all the 3 LEDs, you may want to protect the connection with heat shrink sleeve, adhesive tape or hot melt glue.

After soldering all the 3 LEDs, you may want to protect the connection with heat shrink sleeve, adhesive tape or hot melt glue.

[PHOTO NEEDED HERE!!]

[[File:IMG_2226.JPG|600px]]

===Secure the Display===

===Secure the Display===

Fix the 4 controller modules to the case cover using the 4 bolts and washers attached to every rotary encoder.  

Fix the 4 controller modules to the case cover using the 4 bolts and washers attached to every rotary encoder.  

'''IMPORTANT:''' For avoiding problems while closing the case, i recommend to mount the controller modules with the connectors facing one another, NOT like it's shown in the photo below ('''the two lower modules should be rotated 180º'''). I will update the photo ASAP.

'''IMPORTANT:''' For avoiding problems while closing the case, i recommend to mount the controller modules with the connectors facing one another. See the photo below.

[[File:IMG_1393.JPG|600px]]

[[File:IMG_1393.JPG|600px]]