2,705
edits
Changes
Jump to navigation
Jump to search
Line 350:
Line 350: − + − +
Building a Zynthian Box using an official Kit v2 (view source)
Revision as of 13:22, 29 April 2019
, 13:22, 29 April 2019→Mount the MIDI activity LEDS
When it's done, you have to solder the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (white/yellow). Polarity is important, so don't cross the wires:
When it's done, you have to solder the 2 LED wires (red/black) with the 2 spare wires on the MIDI JST harness (white/yellow). Polarity is important, so don't cross the wires:
* JST Yellow wire (3) => LED's Cathode (LED's black wire/short lead)
* JST White wire (1) => LED's Anode (LED's red wire/long lead)
* JST White wire (4) => LED's Anode (LED's red wire/long lead)
* JST Yellow wire (2) => LED's Cathode (LED's black wire/short lead)
After soldering all the 3 LEDs, you may want to protect the connection with heat shrink sleeve, adhesive tape or hot melt glue.
After soldering all the 3 LEDs, you may want to protect the connection with heat shrink sleeve, adhesive tape or hot melt glue.