2,718
edits
Changes
Jump to navigation
Jump to search
Line 357:
Line 357: − + − + − '''PHOTO NEEDED HERE!!''' − −
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:21, 18 January 2017
, 17:21, 18 January 2017→Connect the Main Ribbon Bus to the RBPi
====Connect the Main Ribbon Bus to the RBPi====
====Connect the Main Ribbon Bus to the RBPi====
It's time to connect the Main Ribbon Bus to the RBPi GPIO. When looking to the case from the front side, the red wire must be in the right, like in the photo:
It's time to connect the Main Ribbon Bus to the RBPi GPIO. When looking to the case from the front side, the red wire must be in the right, like in the photo above.
It's also time to connect the two purple wires to the 2in1 module if you haven't done before. This two wires are for the upper switches: CH(1) and LS(3)
It's also time to connect the two purple wires to the 2in1 module if you haven't done before.
===Connect the Controller Modules (x4)===
===Connect the Controller Modules (x4)===