2,705
edits
Changes
Jump to navigation
Jump to search
Line 320:
Line 320: − +
Building a Zynthian Box using an official Kit v4.1 (view source)
Revision as of 16:11, 2 January 2021
, 16:11, 2 January 2021→Connect the Display
===Connect the Display===
===Connect the Display===
Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be the pin 1, as marked on the display's PCB surface. You '''MUST''' remove the red-jumper that is plugged in the connector's, indicating the pin 1 position too.
Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be on pin 1, as marked on the display's PCB surface. You '''MUST''' remove the red-jumper that is plugged in the connector, indicating the pin 1 position too.