2,718
edits
Changes
Jump to navigation
Jump to search
Line 265:
Line 265: − + Line 295:
Line 295: − + + + Line 301:
Line 303: − + + + Line 307:
Line 311: − + Line 315:
Line 319: − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 18:09, 18 January 2017
, 18:09, 18 January 2017→Case Mounting
=Case Mounting=
=Case Mounting=
===Assembling the Main Computing Block===
===Assemble the Main Computing Block===
The main computing block is composed by the RBPi and the HifiBerry soundcard, and shouold be assembled using the next set of separator & bolts:
The main computing block is composed by the RBPi and the HifiBerry soundcard, and shouold be assembled using the next set of separator & bolts:
[[File:zynthian_mounting_2in1_01.jpg|600px]]
[[File:zynthian_mounting_2in1_01.jpg|600px]]
===Holding the Jack connectors===
===Secure the Jack connectors===
Put the rings on the outer side of the case to avoid damaging the case surface when you tighten the nuts.
[[File:zynthian_mounting_jack_connectors_detail.jpg|600px]]
[[File:zynthian_mounting_jack_connectors_detail.jpg|600px]]
[[File:zynthian_mounting_jack_connectors_top.jpg|600px]]
[[File:zynthian_mounting_jack_connectors_top.jpg|600px]]
===Holding the MIDI-IN connector===
===Secure the MIDI-IN connector===
The ground connector goes upwards. I recommend to remove it with a plier as it could "touch" the controller row-pins when closing the case.
[[File:zynthian_mounting_midi_connector_detail.jpg|600px]]
[[File:zynthian_mounting_midi_connector_detail.jpg|600px]]
[[File:zynthian_mounting_midi_connector_top.jpg|600px]]
[[File:zynthian_mounting_midi_connector_top.jpg|600px]]
===Holding the ScreenTouch===
===Secure the ScreenTouch===
This step is a little bit tricky because the bolts & nuts are tiny, and it have some slack. Don't press too much the nuts. The PCB have to bend a little bit, but not too much. You should be capable of moving the display pushing the borders with your fingers. Later, when the screen is on, you will fine adjust the position for having the margins equalized.
This step is a little bit tricky because the bolts & nuts are tiny, and it have some slack. Don't press too much the nuts. The PCB have to bend a little bit, but not too much. You should be capable of moving the display pushing the borders with your fingers. Later, when the screen is on, you will fine adjust the position for having the margins equalized.
[[File:zynthian_mounting_screentouch.jpg|600px]]
[[File:zynthian_mounting_screentouch.jpg|600px]]
===Holding the Controllers===
===Secure the Controllers===
[[File:zynthian_mounting_controllers.jpg|600px]]
[[File:zynthian_mounting_controllers.jpg|600px]]