Changes

[[File:IMG_3105_OK_1024.JPG|800px]]

[[File:IMG_3105_OK_1024.JPG|800px]]

===Attach the knobs===

===Insert the knobs===

You should attach the knobs into the encoders before closing the case. Push the knobs unto the encoders while pushing the encoder with a finger on the PCB board. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this.

You should insert the knobs into the encoders before closing the case. Push the knobs into the encoders while pushing the PCB with the finger from the rear side. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this. Better skill than strength.

===Attach the rubber feet===

===Attach the rubber feet===