3,418
edits
Changes
Jump to navigation
Jump to search
Line 260:
Line 260: − +
Building a Zynthian Box using official Kits v4.2-v4.6 (view source)
Revision as of 10:38, 24 October 2022
, 10:38, 24 October 2022→Insert the knobs
===Insert the knobs===
===Insert the knobs===
You should insert the knobs into the encoders before closing the case. Push the knobs into the encoders while pushing the PCB with the finger from the rear side. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this. Better skill than strength.
You should insert the knobs into the encoders before closing the case. Push each knob into the encoder while pushing the PCB with the finger from the rear side. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water/oil can be used as lubricant to help with this. '''Better skill than strength.'''
===Attach the rubber feet===
===Attach the rubber feet===