Changes

You can navigate and control the Zynthian UI without knobs/encoders/switches at all, using only the touchscreen.

You can navigate and control the Zynthian UI without knobs/encoders/switches at all, using only the touchscreen.

You can "emulate" the switches by tapping the controller widgets (squares in the 4 corners of the screen). There are short, bold and long actions -- exactly the same workflow as with hardware knobs. The only screen that currently shows the 4 controllers is the "Instrument Control" screen, so some features are only accessible from there. When the "back" widget is not available, you can go back by tapping the top bar.

You can "emulate" the switches by tapping the controller widgets (squares in the 4 corners of the screen). There are short, bold and long actions, same behavior than rotary encoders workflow. Selector screens only have 1 controller widget, but you can also click the zynthian logo at top-right for emulating the "snapshot" switch. The only screen that shows the 4 controllers is the "Instrument Control" screen, so some features are only accessible from there. When the "back" widget is not available, you can go back by tapping the top bar.

You can change the values of the controllers by "sliding" over the widgets. (see the green arrow in the figure here) This is the same as turning the knob. If you are using a mouse, the mouse wheel will modify the parameter value.  

You can change the values of the controllers by "sliding" over the widgets. (see the green arrow in the figure here) This is the same as turning the knob. If you are using a mouse, the mouse wheel will modify the parameter value.