Changes

You can navigate and control the Zynthian UI without knobs/encoders/switches at all, using only the touchscreen.

You can navigate and control the Zynthian UI without knobs/encoders/switches at all, using only the touchscreen.

You can "emulate" the switches by tapping the controller widgets (squares in the 4 corners of a Controller screen). There are short, bold and long actions. Exactly the same workflow as with hardware knobs. When the "back" widget is not available, you can go back by tapping the top bar.

You can "emulate" the switches by tapping the controller widgets (squares in the 4 corners of a Controller screen). There are short, bold and long actions. Exactly the same workflow as with hardware knobs. The only screen that currently shows the 4 controller is the "Instrument Control" screen, so some features are only accessible from there. When the "back" widget is not available, you can go back by tapping the top bar.

You can change the values of the controllers by "sliding" over the widgets. This is the same as turning the knob. If you are using a mouse, the mouse wheel also modifies the parameter.  

You can change the values of the controllers by "sliding" over the widgets. This is the same as turning the knob. If you are using a mouse, the mouse wheel also modifies the parameter.  

When clicking (tapping/touching) the topbar, a "back" event is triggered. It's a quick & dirty fix and probably it will change in the future, but meanwhile it will enable you to fully control Zynthian using the touchscreen if you don't have knob hardware.

When clicking (tapping/touching) the topbar, a "back" event is triggered. It's a quick & dirty fix and probably it will change in the future, but meanwhile it will enable you to fully control Zynthian using the touchscreen if you don't have knobs hardware.

<br clear=all>

<br clear=all>