Changes

# Connect the touch display to the Raspberry Pi using the included instructions

# Connect the touch display to the Raspberry Pi using the included instructions

# Insert the MicroSD card into the Raspberry Pi

# Insert the MicroSD card into the Raspberry Pi

# Connect the Raspberry Pi to the Internet using a Ethernet cable (or connect using WiFi - see below)

# Connect the Raspberry Pi to your local router using a Ethernet cable (or connect using WiFi - see below)

# Connect the power Adapter to the Raspberry Pi and plug it into the wall.

# Connect the power Adapter to the Raspberry Pi and plug it into the wall.

# The Raspberry Pi will boot up Zynthian.

# The Raspberry Pi will boot up Zynthian.

# To configure, connect to Zynthian using a web browser.

# To configure, connect to Zynthian using a web browser.

=Configure Zynthian software=

=Configure Zynthian software=

Connecting to your Zynthian box http://wiki.zynthian.org/index.php/Accessing_Zynthian_from_your_computer

Use a web browser to access your Zynthian box's admin web page .  Depending on your setup you might try to just use '''http://zynthian.local/''' - if that doesn't work You need to enter the IP address of your Zynthian.  

Use a web browser to access your Zynthian box's admin web page .  Depending on your setup you might try to just use '''http://zynthian.local/''' - if that works, you don't need the IPaddress. Otherwise, You have to figure out what the Zynthian box's IP address is. If your Zynthain is connected with an Ethernet cable to your router, your router may have an admin interface (built-in webpage) that may show the IP address of connected devices)

# Login to your Zynthian's admin webpage (password: raspberry)

# Change the display to Generic HDMI

# Change the Audio device to USB device

# Change the Wiring to DUMMIES

  - '''update zynthian software''' from the admin menu

  - '''update zynthian software''' from the admin menu