Changes

[[File:IMG_3105_OK_1024.JPG|800px]]

[[File:IMG_3105_OK_1024.JPG|800px]]

===Attach the knobs===

===Insert the knobs===

You should attach the knobs into the encoders before closing the case. Push the knobs unto the encoders while pushing the encoder with a finger on the PCB board. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water can be used as lubricant to help with this.

You should insert the knobs into the encoders before closing the case. Push each knob into the encoder while pushing the PCB with the finger from the rear side. This will avoid putting too much pressure on the encoders, which can break them. The knobs can be very tight, and a bit of water/oil can be used as lubricant to help with this. '''Better skill than strength.'''

===Attach the rubber feet===

===Attach the rubber feet===

[[file:IMG_2490.JPG|600px]]

[[file:IMG_2490.JPG|600px]]

If you don't get an error screen or a blank screen, you probably you made a mistake during the assembly. You have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].

If you get an error screen or a blank screen, you probably made a mistake during the assembly. You will have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].

If you are using the Aruk RC-3 SD image (which you should), you will notice that the controllers are not working at all. This SD image is pre-configured for working with the kit v2, so you need to configure the software for working with the kit v3. The simplest way of doing it is using the webconf tool:

If you are using the Aruk RC-3 SD image (which you should), you will notice that the controllers are not working at all. This SD image is pre-configured for working with the kit v2, so you need to configure the software for working with the kit v3. The simplest way of doing it is using the webconf tool: