2,705
edits
Changes
Jump to navigation
Jump to search
Line 113:
Line 113: − + − +
Building a Zynthian Box using an official Kit v4.1 (view source)
Revision as of 15:38, 19 October 2020
, 15:38, 19 October 2020→Secure the balanced audio output jack-TS connectors
===Secure the balanced audio output jack-TS connectors ===
===Secure the balanced audio output jack-TS connectors ===
These 2 connectors are pre-assembled together and share a single harness with 3 wires ended with a 3-pin dupont connector.
These are 2 separated connectors with a 3-wire harness each, ended with 3 x 1-pin dupont connectors. One of them have a red circle sticker that '''MUST''' be mounted on the Right Audio Out.
Insert the jack connectors into the 2 holes labeled as ''audio OUT''. You have to insert them from inside the case and secure them with the washers and nuts from the outside. The washers will keep the nut from damaging the case. Use a wrench for tightening the nuts, but not too much!!
Insert the jack connectors into the 2 holes labeled as ''audio OUT''. You have to insert them from inside the case and secure them with the washers and nuts from the outside. The washers will keep the nut from damaging the case. Use a wrench for tightening the nuts, but not too much!!