Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be the pin 1, which as marked on the display's PCB surface. Probably you need to remove the red-jumper that is plugged in the connectors pins 1-2, indicating the right position. | Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be the pin 1, which as marked on the display's PCB surface. Probably you need to remove the red-jumper that is plugged in the connectors pins 1-2, indicating the right position. |