2,718
edits
Changes
Jump to navigation
Jump to search
Line 268:
Line 268: − + −
Building a Zynthian Box using an official Kit v4.0 (view source)
Revision as of 23:34, 27 July 2020
, 23:34, 27 July 2020→Connect the Display
Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be the pin 1, which as marked on the display's PCB surface. Probably you need to remove the red-jumper that is plugged in the connectors pins 1-2, indicating the right position.
Connect the ribbon's 26-pin connector to the display's connector. '''Pay attention to the orientation'''. The red wire should be the pin 1, which as marked on the display's PCB surface. Probably you need to remove the red-jumper that is plugged in the connectors pins 1-2, indicating the right position.
{{WarningBox|Please, double check this step carefully because you could break the display if it's connected reversed!!}}
Please, double check this step carefully because you could break the display if it's connected reversed!!
[[File:Screen&Ribbon.JPG|600px]]
[[File:Screen&Ribbon.JPG|600px]]