2,705
edits
Changes
Jump to navigation
Jump to search
Line 160:
Line 160: − + Line 250:
Line 250: − + + +
Building a Zynthian Box using an official Kit v4.0 (view source)
Revision as of 16:17, 9 August 2020
, 16:17, 9 August 2020→Mount the MIDI activity LEDS
* JST Yellow wire (2) => LED's Cathode (LED's short lead)
* JST Yellow wire (2) => LED's Cathode (LED's short lead)
Since the LED's leads are too long, you will want to cut them down to about 7-8mm. Make sure you remember which lead is the short one.
Since the LED's leads are too long, you will want to cut them down to about 7-8mm. Make sure you remember which lead is the short one. When inserting the dupont connector, if you feel that it doesn't grab the pins enough, you should press the tiny metal-jacket inside the plastic capsule to make it narrow. It's easy, simply put the dupont connector over the desk and press the metal with the screwdriver tip or something like that.
[[File:IMG2406.JPG|800px]]
[[File:IMG2406.JPG|800px]]
===Mount the Controllers===
===Mount the Controllers===
Plug a wire on each controller. Fix the controllers in each corner using the nuts and washers attached to them
Plug a wire on each controller. Fix the controllers in each corner using the nuts and washers attached to them.
'''Don't mount the controllers like in the photo''', do it upside-down to avoid pressing the MIDI LED pins. I will update the photo ASAP.
[[File:Rotary&wire.JPG|400px]]
[[File:Rotary&wire.JPG|400px]]