2,718
edits
Changes
Jump to navigation
Jump to search
Line 294:
Line 294: − '''PHOTO NEEDED HERE!!'''+ Line 308:
Line 308: − '''PHOTO NEEDED HERE!!''' => detail controller connection+ − − '''PHOTO NEEDED HERE!!''' => controller connection in the case Line 318:
Line 316: − '''PHOTO NEEDED HERE''' => Detail 2in1 connections+ + + Line 326:
Line 326: − '''PHOTO NEEDED HERE''' => Detail HifiBerry audio-out connecter+ −
Building a Zynthian Box using an official Kit (view source)
Revision as of 13:27, 17 January 2017
, 13:27, 17 January 2017→Connecting everything
In that point you should have something like this:
In that point you should have something like this:
[[File:Zynthian_mounting_ribbon_wiring.jpg|600px]]
====Connect the Main Ribbon Bus to the RBPi====
====Connect the Main Ribbon Bus to the RBPi====
So '''you should look at your controller modules from bottom side and with the pin-row on the top of PCB!'''
So '''you should look at your controller modules from bottom side and with the pin-row on the top of PCB!'''
[[File:Zynthian_mounting_controllers.jpg|600px]]
'''Note:''' Some encoders have reversed pin ordering, so, if you buy the encoders by yourself, perhaps you have to change A and B pins.
'''Note:''' Some encoders have reversed pin ordering, so, if you buy the encoders by yourself, perhaps you have to change A and B pins.
===Connect the 2in1 Module===
===Connect the 2in1 Module===
Connect the 6-pin dupont wire to the 2in1 module. Numbering is from left to right and pin 1 is the brown wire:
Connect the 6-pin dupont wire to the 2in1 module. Numbering is from left to right and pin 1 is the brown wire:
[[File:Zynthian_mounting_2in1_top.jpg|600px]]
Also connect the DIN-5 connector (MIDI-IN) to the 2in1 module. It's the 2-pin connector labeled as MIDI-IN.
Also connect the DIN-5 connector (MIDI-IN) to the 2in1 module. It's the 2-pin connector labeled as MIDI-IN.
[[File:Zynthian_mounting_2in1_case.jpg|600px]]
===Connect the Jack connectors===
===Connect the Jack connectors===
And finally, connect the Jack connectors to the auxiliar on-board audio-out connector in the HifiBerry soundcard. This is the 3-pin connector that you soldered before:
And finally, connect the Jack connectors to the auxiliar on-board audio-out connector in the HifiBerry soundcard. This is the 3-pin connector that you soldered before:
[[File:Zynthian_mounting_connectors.jpg|600px]]
=Testing the Zynthian Box=
=Testing the Zynthian Box=