2,718
edits
Changes
Jump to navigation
Jump to search
Line 181:
Line 181: − + Line 193:
Line 193: + +
Building a Zynthian Box using an official Kit (view source)
Revision as of 12:51, 17 January 2017
, 12:51, 17 January 2017→Building the Zynthian Kit parts
These are the steps for building the 2in1 module:
These are the steps for building the 2in1 module:
0. Be sure that you have readed and understanded this recommendations.
0. Be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
1. Place all the components in the upside of the PCB (the labeled side!). Put attention to the orientation of the ICs and diode.
1. Place all the components in the upside of the PCB (the labeled side!). Put attention to the orientation of the ICs and diode.
2. Solder the encoder and capacitor carefully.
2. Solder the encoder and capacitor carefully.
+ 40 row-pin GPIO male connector, for connecting the '''main ribbon bus cable'''
+ 40 row-pin GPIO male connector, for connecting the '''main ribbon bus cable'''
+ 3 pin header connector, for connecting the extra audio line-out Jack connectors
+ 3 pin header connector, for connecting the extra audio line-out Jack connectors
Soldering the big 40-pin connector can be difficult if you don't have enough practice. Please, before starting be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
[[File:Hifiberry_dacplus_extra_connectors_unassembled.jpg|600px]]
[[File:Hifiberry_dacplus_extra_connectors_unassembled.jpg|600px]]