2,718
edits
Changes
Jump to navigation
Jump to search
Line 229:
Line 229: − '''PHOTO NEEDED HERE!!'''+
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:24, 16 January 2017
, 17:24, 16 January 2017→2in1 Module 6-pin Dupont Wire
Next, you take the "10cm 6-pin Dupont Connector Wire". This is used to connect the 2in1 module to the RBPi GPIO:
Next, you take the "10cm 6-pin Dupont Connector Wire". This is used to connect the 2in1 module to the RBPi GPIO:
[[File:2in1_dupont_wire.jpg|600px]]
You have to connect it to the middle male connector of the Ribbon Bus Cable following the next scheme:
You have to connect it to the middle male connector of the Ribbon Bus Cable following the next scheme: