2,718
edits
Changes
Jump to navigation
Jump to search
Line 186:
Line 186: − + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
Building a Zynthian Box using an official Kit (view source)
Revision as of 19:52, 15 January 2017
, 19:52, 15 January 2017→Connecting everything
===Holding everything to the case===
===Holding everything to the case===
===Connecting everything===
=Connecting everything=
=== Controller Module x 4 ===
This step is a bit tricky. Remember that, if you follow the instructions before, you have soldered the pin-rows in the bottom side of PCBs, so numbering is reversed when looking from bottom. You can use a little trick: if you rotate the PCB 180º, then numbering is "left to right" again ;-)
So '''you should look at your controller modules from bottom side and with the pin-row on the top of PCB!'''
'''PHOTO NEEDED HERE!!'''
'''Note:''' Some encoders have reversed pin ordering, so, if you buy the encoders by yourself, perhaps you have to change A and B pins.
[[File:wiring_scheme_controllers_single.png|600px]]
[[File:zynthian_inside_01.jpg|600px]]
'''Warning:''' In this photo the controller modules wiring is reversed (1 by 2, 3 by 4). I will change it ASAP ;-)
=== 2in1 ===
The 2in1-PCB must be connected using one of the mini ribbon cables. The 6-pin connector must be located towards the PCB. Pin 1 is on the bottom left (component side up). On the other end of the cable there are 1-pin female connectors. They must be connected to the following pins on the (male) 40-pin-conenctor in the middle of the main ribbon cable.
{| class="wikitable"
! Wire no. || Function || GPIO no. || Pin on Raspi no.
|-
| 1 || Vdc 3.3V || 3.3V || 1
|-
| 2 || RxD || RxD || 10
|-
| 3 || I2C SDA1 || 08 || 3
|-
| 4 || I2C SCL1 || 09 || 5
|-
| 5 || Vdc 5V || 5V || 2/4
|-
| 6 || GND || GND || 6/9
|-
|}
[[File:Cable-schema-2in1.png|600px]]
Next connect the DIN socket (MIDI) to the 2in1-PCB. The connector on the PCB is the 2-pin one located in the upper right corner of the PCB.
{| class="wikitable"
! Wire no. || Function || MIDI-IN pin no.
|-
| 1 || MIDI-IN || 2 (MIDI connector: 2nd from left)
|-
| 2 || MIDI-IN || 4 (MIDI connector: 2nd from right)
|-
|}
====
====