2,718
edits
Changes
Jump to navigation
Jump to search
Line 107:
Line 107: − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 12:28, 12 January 2017
, 12:28, 12 January 2017→Controller Modules
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
5. Solder the pin-row carefully.
5. Solder the pin-row carefully.
6. Bend the pin-row outwards a little bit, like shown in the photo.
6. Bend the pin-row outwards a little bit, like shown in the photo. You can use a screwdriver or similar to do it.
[[File:Controller_single_ensambled_01.jpg|600px]]
[[File:Controller_single_ensambled_01.jpg|600px]]