2,706
edits
Changes
Jump to navigation
Jump to search
Line 343:
Line 343: + + + + Line 355:
Line 359: − − This scheme shows the switches numbering & naming: − − [[File:zynthian_ui_legend.png]]
Building a Zynthian Box using an official Kit (view source)
Revision as of 21:37, 9 July 2017
, 21:37, 9 July 2017→Controller Module 4-pin Dupont Wires (x 4)
====Controller Module 4-pin Dupont Wires (x 4)====
====Controller Module 4-pin Dupont Wires (x 4)====
The next scheme shows the numbering/naming used for encoders and switches:
[[File:zynthian_ui_legend.png]]
Take the 4 x "20cm 4-pin Dupont Connector Wires". These wires are used to connect the 4 controller modules to the RBPi GPIO:
Take the 4 x "20cm 4-pin Dupont Connector Wires". These wires are used to connect the 4 controller modules to the RBPi GPIO:
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
====2in1 Module 6-pin Dupont Wire====
====2in1 Module 6-pin Dupont Wire====