2,706
edits
Changes
Jump to navigation
Jump to search
Line 158:
Line 158: − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 15:45, 9 May 2017
, 15:45, 9 May 2017→Assembling the Controller Modules
0. Be sure that you have read and understdood [[#Some_general_recommendations|these recommendations]].
0. Be sure that you have read and understdood [[#Some_general_recommendations|these recommendations]].
1. Bend the encoder's securing tabs to 75º, so you can insert it in the upside of the PCB (the labeled side!). Please, be very careful when bending the tabs as the encoder case is quite fragil and could be deformed. I recommend to use a small plier and not reaching to 90º.
1. Bend the encoder's securing tabs to 75º, so you can insert it in the upside of the PCB (the labeled side!). Please, be very careful when bending the tabs as the encoder case is quite fragil and could be deformed. I recommend to use a small plier and not reaching to 90º.
2. Place the 100nF capacitor in the C1 position (the most right!). This is for debouncing the push switch.
2. Place the 100nF capacitor in C1 position (the most right!). This is for debouncing the push switch.
3. Place the 2 x 10nF capacitors in C2 & C3 positions. These are for debouncing the rotary encoder contacts.
3. Place the 2 x 10nF capacitors in C2 & C3 positions. These are for debouncing the rotary encoder contacts.
3. Solder the encoder and capacitors carefully.
3. Solder the encoder and capacitors carefully.