2,718
edits
Changes
Jump to navigation
Jump to search
Line 358:
Line 358: +
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:21, 18 January 2017
, 17:21, 18 January 2017→Connect the Main Ribbon Bus to the RBPi
It's time to connect the Main Ribbon Bus to the RBPi GPIO. When looking to the case from the front side, the red wire must be in the right, like in the photo above.
It's time to connect the Main Ribbon Bus to the RBPi GPIO. When looking to the case from the front side, the red wire must be in the right, like in the photo above.
It's also time to connect the two purple wires to the 2in1 module if you haven't done before. This two wires are for the upper switches: CH(1) and LS(3)
It's also time to connect the two purple wires to the 2in1 module if you haven't done before. This two wires are for the upper switches: CH(1) and LS(3)