2,718
edits
Changes
Jump to navigation
Jump to search
Line 150:
Line 150: − + − + − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:48, 17 January 2017
, 17:48, 17 January 2017→Assembling the Controller Modules
These are the steps for building one module:
These are the steps for building one module:
0. Be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
0. Be sure that you have readed and understanded [[#Some_general_recommendations|these recommendations]].
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
1. Bend the encoder's securing tabs to 75º, so you can insert it in the upside of the PCB (the labeled side!). Please, be very careful when bending the tabs as the encoder case is quite fragil and could be deformed. I recommend to use small pliers and not reaching to 90º.
2. Place the capacitor in the C1 position (the most right!)
2. Place the capacitor in the C1 position (the most right!)
3. Solder the encoder and capacitor carefully.
3. Solder the encoder and capacitor carefully.
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
5. Solder the pin-row carefully.
5. Solder the pin-row carefully.
6. Bend the pin-row outwards a little bit, like shown in the photo. You can use a screwdriver or similar to do it.
6. Bend the pin-row outwards a little bit, like shown in the photo. You can use a screw-driver or similar to do it.
[[File:Controller_single_ensambled_top.jpg|290px]]
[[File:Controller_single_ensambled_top.jpg|290px]]