2,718
edits
Changes
Jump to navigation
Jump to search
Line 127:
Line 127: − + − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:30, 17 January 2017
, 17:30, 17 January 2017→Some general recommendations
'''3.''' After finishig the soldering, brush smoothly all the contacts. You may use a small iron brush. After that, blow over the circuit to remove any remaining solder-tin.
'''3.''' After finishig the soldering, brush smoothly all the contacts. You may use a small iron brush. After that, blow over the circuit to remove any remaining tin.
'''4.''' Inspect visually all the soldered contacts. You could use a magnifying glass for verifying that every soldered pin looks good. If you are not sure, perhaps you could add more tin-paste or re-solder the pin. Also, you could use a multimeter for testing the dubious contacts.
'''4.''' Inspect visually all the soldered contacts. You could use a magnifying glass for verifying that every soldered pin looks good. If you are not sure, perhaps you could add more tin or re-solder the pin. Also, you could use a multimeter for testing the dubious contacts.