2,718
edits
Changes
Jump to navigation
Jump to search
Line 215:
Line 215: + + + +
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:26, 17 January 2017
, 17:26, 17 January 2017→Clonic TouchScreen
If you have a clonic PiTFT 2.8' touchscreen, probably you don't have the side 26-pin male connector soldered in the board, so you should solder it by your own. Also, normally the female connector in the clonic versions is higher that in the original and more annoying yet, so, you will want to remove it with a saw. If you do so, i also recommend to use a vice.
If you have a clonic PiTFT 2.8' touchscreen, probably you don't have the side 26-pin male connector soldered in the board, so you should solder it by your own. Also, normally the female connector in the clonic versions is higher that in the original and more annoying yet, so, you will want to remove it with a saw. If you do so, i also recommend to use a vice.
After removing the female connector, the side connector must be soldered. Note that you have to place it on the bottom side of the board, so you should solder the contacts on the top side.
'''WARNING!''' Soldering the 26-pin connector can be difficult if you don't have enough practice. Please, before starting be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
[[File:Pitft_clonic_touchscreen_unassambled.jpg|600px]]
[[File:Pitft_clonic_touchscreen_unassambled.jpg|600px]]