2,718
edits
Changes
Jump to navigation
Jump to search
Line 148:
Line 148: + − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 12:47, 17 January 2017
, 12:47, 17 January 2017→Assembling the Controller Modules
These are the steps for building one module:
These are the steps for building one module:
0. Be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
2. Place the capacitor in the C1 position (the most right!)
2. Place the capacitor in the C1 position (the most right!)
3. Solder the encoder and capacitor carefully. Avoid overheating! => [[#Some_general_recommendations|Read this!]]
3. Solder the encoder and capacitor carefully.
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
5. Solder the pin-row carefully.
5. Solder the pin-row carefully.